This titanium shaft is far tougher than the stock aluminum diff all while maintaining light weight. As a plus all our new shaft designs allow for the use of a thrust bearing on the outside of the diff instead of a normal bearing to handle side load much better. This leads to a smoother, longer lasting diff.
Version 2 molded A-Arms for your RX28. These are the hard arms. Hard arms are better for higher bite conditions as they provide sharper mid corner steering while reducing traction rolling. This listing includes the new Gen2 dedicated left and right arms.
This set includes:
2 x Upper Arms (Gray/Hard)2 x Lower Arms (Gray/Hard)4 x 3.55mm Aluminum Pivot Balls2 x M2x6mm Screws2 x M2x8mm Screws2 x M1.2x5mm self tapping screws2 x M1.2x4mm self tapping screws
Version 2 molded A-Arms for your RX28. This is the G2 arm sets with dedicated left and right arms.
This set includes:
-2 x Upper Arms (Black/Medium)
-2 x Lower Arms (Black/Medium)
-4 x 3.55 Aluminum Pivot Balls
-2 x M2x6mm Screws
-2 x M2x8mm Screws
-2 x M1.2x5mm self tapping screws
-2 x M1.2x4mm self tapping screws
The Wing Things are designed to make mounting your wing much easier. Install the screw from the bottom of the body and thread them into the wing thing threads. You can hold the wing thing with a 4.5mm hex wrench to fully tighten.
The total weight of the 2 wing things and 2 M2x4 is roughly 0.5g; about the same weight as using a couple of steel hex nuts and 6mm steel screws that are typically included in body sets.
Make your PN Racing Gear diff last forever when installing these gear diff covers. Click on the video link to see the instructions on how to use them.Watch Video
Really good plastic wheel nuts and our awesome plastic left rear wheel nut included in this kit. The left rear wheel nut allows you remove the outer bearing/bushing on the wheel for easier wheel changes and reduced parts count.
2x Kugellager für das Hauptzahnrad.Passend für Reflex Racing, PN Racing, Nexx Racing Hauptzahnräder.Dimensionen: Innendruchmesser 4mmAussendurchmesser 7mmBreite 2mm
Hard coated 3.5mm Ball Studs. Made from 7075 T6 Aluminum and finished in super hard copper coated coating, these studs are super light weight, smooth and durable.