RTA V3 Ersatzteile
3.1 x 4.5mm shims to tune your car This kit include : 0.05mm shims x 10pcs 0.1mm shims x 10pcs 0.2mm shims x 10pcs 0.3mm shims x 10pcs
Long 3mm balls for RTA V3
Titanium diff axle for the RTA V3
RTA V3 rear pod Strong and lightweight, this new pod provides improved rear stability thanks to a lower motor mount compared to previous versions.
Spare part for side springs carbon plate RTA V3
New front end for the RTA V3 This front end is 4mm wider than on the V2 The upper arms from the V2 are compatible with this version.
6*3mm aluminium balls for RTA V3 Warning: Aluminum is a softer material than steel. Do not overtighten during installation, as excessive tightening may damage or deform the ball and affect its performance.
Replacement pins for V2 Front End Arms (RT003 V2)
Body post for the RTA V3 and the new bumpers
Center pivot holder for the RTA V3 This parts is made of aluminium 7075-T6
Original knuckles left and right for RTA V3 chassis. Camber : 0° These parts are machining in good quality anodized aluminium 7075-T6.
Black machined cut spur for the RTA V3
Original front springs A-Arms for RTA V3 chassis. These springs are custom made to perfectly adapt to the characteristics of the RTA V3 chassis.
Pivot slider for the RTA V3 chassis. The rear roll center is two millimeters below the chassis. The part is made of 7075-T6 aluminum.
10 x 2.381 mm ceramic balls for the RTA V3 differential
This kit includes: CS head screws 6 mm ×5 CS head screws 5 mm ×13 CS head screws 4 mm ×11 Button head screws 5 mm ×4 Blind screw M2 screws 4 mm ×2 Blind screw screws 2 mm ×4 Blind screw screws 5 mm ×2
Set of 3mm ball caps for RTA V3
This kit includes: Differential thrust bearing Spur bearing Differential bearing Circlips M3 screws for diff collar O-rings
New ball bearing set for RTA V3 chassis. Reduced friction and increased lifespan. Very high quality bearings. Tested and validated for use on any type of mini-z.
Asymmetric servo horn designed to compensate for steering linkages of different lengths, ensuring balanced and precise steering geometry.
Carbon side links holders for RTA V3.
Steering turnbuckles set for the RTA V3
Original side spring set for the RTA V3
Diff rings for the RTA V3 differential These parts are made from 7075-T6 aluminum
Replacement pins for V2 Front End Arms (RT003 V2)
Optimized version of the RTA wheel axles: Diameter of the axle machined and controlled to the hundredth of a mm to eliminate the play between the bearings and the axle. Your wheel is perfectly guided on the axle, thus optimizing contact between the tire and the track. Materials more resistant to wear Compatible with most 2WD using the same type of wheel axle. Warning: Aluminum is a softer material than steel. Do not overtighten during installation, as excessive tightening may damage or deform the ball and affect its performance.
Side link shafts for the RTA V3. Part made of 7075-T6 aluminum.
Diff plates for the RTA V3 differential Remember to sand the diff plates using 2000 and 3000 grit sandpaper.
Central shock ball for the RTA V3
Carbon plate for rear damper RTA V3. This part is machining in carbon.